londonsean69
4th October 2009, 01:20 PM
For some bizarre reason I have made my RP3 tubes (the upright struts between the 2 bent rear panel tubes RP1&2) out of 19 round, rather than 19x19 erw.
They are only tacked in.
Should I bother changing them, or leave them as they are?
The only problem I can see with them 'might' be drilling into round for the rivets, if I put some there.
Sean
They are only tacked in.
Should I bother changing them, or leave them as they are?
The only problem I can see with them 'might' be drilling into round for the rivets, if I put some there.
Sean