View Full Version : Aluminium Bonnet
deezee
1st December 2009, 01:01 PM
So I have my nosecone and scuttle now from Triton / SSC. Now the aluminium I have for the bonnet is 1mm but the recess in the scuttle and nosecone is deeper (say 3-4mm). So how do I get the bonnet flush with the scuttle?
Do I fit aluminium to the scuttle? Or perhaps fit some seals?
HandyAndy
1st December 2009, 01:07 PM
i would suggest the foam strip, on both edges of the scuttle & nose to raise the bonnet up a little, also you,ll have edging trim on the bonnet too so allow enough clearance for that ;) :)
cheers
andy....... the very nice man indeed :D
spud69
1st December 2009, 02:10 PM
So I have my nosecone and scuttle now from Triton / SSC. Now the aluminium I have for the bonnet is 1mm but the recess in the scuttle and nosecone is deeper (say 3-4mm). So how do I get the bonnet flush with the scuttle?
Do I fit aluminium to the scuttle? Or perhaps fit some seals?
You can use these from car builder solutions:
http://www.cbsonline.co.uk/neoprene-d-section-self-adhesive-21-c.asp
They also do the edging trim for IVA. Works well.
AndyH
vBulletin® v3.6.4, Copyright ©2000-2024, Jelsoft Enterprises Ltd.