PDA

View Full Version : Front upper wishbone jig


martin62
11th April 2010, 11:02 PM
Hi can someone help I was makine my front upper wishbone jig today and was trying to find a measurment for the 2 front 25x6 angled brackets.what I am looking for is the lenght of the front edge which is on 5.12 on page 63. Otherwise had a good day got all my front suspension brackets lined up and tacked up 7.30am start and had a very nice visit from transverse which was great having someone likeminded to chat too.

Bonzo
12th April 2010, 09:47 AM
That measurement can be nicked from the drawing on page 61. :)

The length is given as 236mm to the centre of the wishbone bush tube

So 236mm + half the width of the bush tube. On the book spec tube, this is approximately 17mm .... Unless you have a tape measure that has fractions of a mm graduations on it :D :D

I make the overall length of the upper front wishbone 253mm.

martin62
13th April 2010, 01:00 AM
That measurement can be nicked from the drawing on page 61. :)

The length is given as 236mm to the centre of the wishbone bush tube

So 236mm + half the width of the bush tube. On the book spec tube, this is approximately 17mm .... Unless you have a tape measure that has fractions of a mm graduations on it :D :D

I make the overall length of the upper front wishbone 253mm.

Hi Ronnie sorry if I was not clear in my question but I ment the height of the 2 angled pieces that are set at 98 degrees thanks Aidan