saturn dash bottom edge?

[baz-r]

does the bottom edge of a saturn dash comply with iva regs or do i need to extend mine.
it has a radius but finishs at 90deg in a J fasion

[shh120m]

It needs edge trimming, and the passenger side will need boxing in for iva.

[davedew]

I was unsure about the bottom edge of the dash so I extended it into a full 180 degree radius. Also the center section of the dash did not meet with the top of the transmission tunnel so I extended that at the same time.

Boxing in the underside of the passenger side is not necessary for IVA. Gus didn't on his. All they made him do was add a piece of rubber U-trim to the return lip on the scuttle as it overhung the top rail.

[shh120m]

depends, if there is wiring under there

[davedew]

Gus did have wiring but it was neatly wrapped so not likely to get caught by a passenger