Great progress and heartening to see someone building in a similar sized garage to me. I'm interested in the suggestion that you screw the chassis to the build table to keep it flat and prevent distortion. That was my plan but I am sure someone warned off doing that in case it masked distortion which only then became apparent once the chassis was unscrewed. As the consensus on here seems to be that that is not the case, I'll follow your lead.
I look forward to seeing your build progress. |
Quote:
|
Quote:
don't see why not if you feel happier just keep moving back and fore, side to side to minimise / equal the forces , looking good by the way and good progress |
stop!
the two bars that go down from sb3 rear end of the tunnel have you fitted them per the book? you are using a talon chassis / diff setup yes? they are not welded per the book i will get the sizes and post them shortly |
|
Quote:
|
ok mark the centre line of sb3, then looking down the tunnel from the front of the car the outer edge of the box section to the right should be 89mm from the centre line. the left hand box section outer edge shoud be 137mm from centre line. the 5mm plate that the diff mount goes too gets welded to the inner edge of that box section, against the back edge of br12/sb3 big part of the flange to the top
|
Quote:
|
|
|
All times are GMT +1. The time now is 07:15 AM. |
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.