Which engine are you using / planning
What Engine are you using or planning.
|
i,m using the 1.8 cvh that came with my donor, tho i,m sure it,ll go bang in time for winter ;)
i,m being like a boy scout " be prepared" & so i,m collecting the bits i,ll need to rectify the above problem , bike carbs, megajolt & an engine that starts with a Z :D & fitting a prop capable of more than the cvh can give;) cheers andy |
Toyota 4age 20v 1.6
|
Rolls Royce 27 litre V12 Merlin.
Actually I'm lying - 2.0 DOHC 8 valve. |
|I'm using a Escort RS2000 16v. Which is virtually the same as the Sierra DOHC but has a tuned head for that extra 50bhp :D
|
Donor engine 1.8 CVH, will try bike carbs when its on the road.
|
2.9 12v V6 Efi
Tt |
Donor 1.8 Pinto for ease of registration for me then will upgrade to something meatier later - maybe a K Series or an Ecotec
|
Quote:
Ray:) |
1.8 Zetec for starters ........ Keeping the Redtop for another day :)
Enoch I just happen to know where I can lay my hands on a RR Merlin engine locally !! A: I can't lift it ....& ....B: The museum will be well narked if I borrow it :eek: :D :D |
lol
Ray:) |
Nissan SR20de 2.0 n/a
|
Quote:
I4 2.0 16V RS2K = 150BHP I4 2.0 16V = 134BHP I4 2.3 16V = 144BHP TT |
C20 XE for me.
|
Quote:
|
I'll be going for a 1.8 CVH with bike carbs + megajolt from the start. It will be getting a full rebuild in the next few months once I have the chassis rolling.
|
im using a 1.8 zetec with the original 130bhp ecu and an aftermarket plenum.
cheers Andy |
im keeping my options open at the moment but somthing tells me it will be a zetec 2.0 from the power to cost of install :confused:
theres loads of good motors that could be used i quiet fancy a rover k (light) or redtop if a cheep bell housing comes up. |
2.9 24 valve Cosworth V6 here.
D. |
1.8 BMW single cam to get it through the IVA. Then one day when I'm rich a Mazda Wankel (yes I know I will go blind!!).
|
honda super blackbird for me
tilly |
Toyota 20v 1600 blacktop
|
2.1 Pinto to replace a 2.1 Pinto that i killed, then i will rebuild the original 2.1 Pinto. Current build has Cosworth rods, V6 pistons, 10.6 to 1 comp and a new Kent RL31 cam.
Emissions are 3.5 CO and 1200 ppm HC on my V5 so anything i put in should pass MOT |
I shall be using the fine lump of metal that is the 8v DOHC...what a beast.
Have been thrashing the missus 2.0 Mondy around this week as I am off work & imagining what it would feel like with half the weight:D The fat old thing likes to rev she does. |
R1 bike engine
|
2l Pinto with twin 40s in one. 2l zetec with throttle bodys on secound car.:D
|
will be interesting to put the pinto against the zetec frankie. how far on is the second one now?
|
Quote:
|
I want lunch control, help keep my dinner in when booting it down the lanes :)
TT |
DOHC 8v that came with the donor, but I have a 1.6 Zetec JIC. Would prefer the age related plate though.
|
2.3L Ford Pinto, Turbo engine.
cheers, Bill. |
Now... is it a Pinto or is it a Lima??
TT |
Sorry! my mistake. Its the 2.3 lima. Thats the Brit coming out of me I guess.
|
I think peeps often call it as pinto as it looks quite similar but aparently has very few common components.
TT |
MX5 engine gearbox and ecu, fine piece of kit.
|
I'm planning on using the 1.6 Pinto from my donor, with minimal work (a good clean-up, new points, oil, filter and cam belt will be about it) to get me IVA'd. Then replace it with a road tuned 2l Pinto (a nice winter's project).
|
Points????
TT |
Yes, points. Can you tell what an old fart I am?
Will fit a maga-jolt on the 2l. |
Where's the engine comming from, sierras have electronic ignition.
TT |
:o
yes, your right TT and just had a look under the bonnet to double check. I was making the assumption on such an old car it would be points. Nice not to have them, they were a bit of a pain to set up. Note to self: read Haynes manual more thouroughly! :D |
All times are GMT +1. The time now is 03:50 AM. |
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.