talon wishbones/mx5
 

hi i have a set of talons wishbones, anyone else using them have any pictures of them fitted, trying to see what i need to salvage from the donor before i attack it witha grinder.
cheers

You need the rear uprights, half shafts and brakes with hand brake cables (DO NOT CUT THESE !!!) If like most you can't get the outer lower wishbone bolt to move let alone out cut through it with a cutting disk, you can always drill the rest of the bolt out later. If the top mount of the upright is completely shot replace with a 90A shore polyurethane replacement with a stainless crush tube with a 12mm through hole (these will be in my online shop soon).

This is what the TMXR wishbones look like when assembled with the upright in place, the gap will take a standard 34mm coilover.

Sent you a PM

would these be the wishbones i would have to use on my chassis
thats book spec
but im using a mx5 as a donor

Yeah they would suit your chassis

thanks guys i can start to strip the donor now i need the diff out to order the housing from phil

Early cars are fitted with the smaller/shorter diff and the later cars are fitted with the larger/longer diff, the covers are not inter-changable between the two.

You might find this link helpful....

http://www.miata.net/garage/diffguide/index.html