Help needed
Hi guys how are you all?
Ok so I'm ready to start my build and hit a snag already been pricing my metal for the chassis and its going to cost nearly 300 delivered from my local metal suppliers is this correct? I have seen guys on here paying less then 100!! Just think they are trying to rip me off already! Thanks justin |
They certainly are:eek: :eek:
|
What have you priced up for just the box section if so then yes it is expensive.
Have you asked about the ally aswell ok it would still be expensive but noy as bad Arfon |
Where in the world are you? People might be able to suggest an alternative source.
|
Quote:
I also asked for shs to see if that was cheaper it would of been 2mm wall but that worked out more expensive! |
Quote:
|
You can get a pre cut chassis pack for less than that. Pm phil at Talon, I am sure he can sort you out, and it saves a load of haste cutting all of those angles !:eek:
|
yep pre-cut is the way to go.
|
Quote:
|
I got all my steel from IS&G Steel Stockholders, can't remember exactly how much but it came in under £100. I had to drive over there with my hacksaw and cut the 6m lengths in half, then straped the lot on the roof.
They have a branch in Ipswich, about 54 miles from Great Yarmouth. |
All times are GMT +1. The time now is 09:25 AM. |
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.