GRP side panels / 'H' tube alignment - good enough?
A question for everyone who has fitted their GRP sides. Would you go with panel alignement that was as good (or bad) as what is shown below?
Essentially - where the panels bend inwards, i.e. where the dashboard side of the scuttle sits - is sitting about 5mm forward of where the chassis rails have the same bend. I don't have The Book to hand, but think it's called tube 'H'. Offside Nearside |
Think I would of tried to nudge it back a little. But 5mm is nothing. Esepecially with fibreglass.
|
Quote:
|
My join is right by roll cage above wing. If you get a right tight fit, couple of coloured rivets to keep all in place you don’t really notice it. I was lucky and have ball bodywork so used a tiny bit of black silicon to cover joint. Bit like you see on other vehicles.
|
All times are GMT +1. The time now is 05:15 AM. |
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.