Front Camber Adjust Nut
Hi there, what have you guys done re covering the front camber adjust nut for the IVA test? I can't find anything that I think the inspector will be happy with:(
Any ideas welcome. Enoch |
|
Some large diameter cable heat shrink should do fine Dave
|
Quote:
http://www.audiospares.com/product.p...2&cat=0&page=1 AndyH |
Thanks Spud, I thought Ash found out that heatshrink was not permitted any more?
I am thinking of speaking to my local test station and asking a few direct questions to try and elliminate some of the variances. Thanks again, Enoch |
I think Ash just had a very pedantic tester, as far as i'm aware heat shrink is fine but if you're not sure cable glands can be used just need to get the correct size.
AndyH |
Thanks again Andy. I think I will try to speak to the IVA centre and see if they are equally pedantic when the build is not being covered by a national magazine:D
Best and all that. Enoch |
Spud69
Jumped in without reading properly, have since read and realised my mistake. Cheers |
All times are GMT +1. The time now is 06:18 AM. |
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.