Haynes Forums

Haynes Forums (http://www.haynes.co.uk/forums/index.php)
-   Chassis (http://www.haynes.co.uk/forums/forumdisplay.php?f=4)
-   -   Sierra Diff Mount (http://www.haynes.co.uk/forums/showthread.php?t=14063)

CarlW 7th April 2017 07:33 AM

Sierra Diff Mount
 
Hi Guys,

About to weld new plates where the diff bolts too. I have made two new ones for my build as I am using the wider sierra diff 7.5 one. The original plates wouldn't have been butt up to the up rights so made new ones wider.
Question is, have you all used the same hole positions for the vertical diff height? i.e if I use the same hole positions as supplied with the kit only wider apart but height the same?
Or is there a measurement from say the centre of the prop-shaft flange to somewhere I could measure and maintain?


Cheers,


All times are GMT +1. The time now is 08:03 AM.

Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.