Interior projctions - the chassis
So, I was just down the garage for a crafty smoke, and got to thinking.....
On the IVA, most things that are contactable have to have a 2.5mm radius. What about the exposed chassis rails in the cockpit area?? The rails I mean are the ones that hold the side panels - no idea what tubes they are (book in garage) but includes diagonals as well as top and bottom rails. I don't intend to trim mine, would this pose a problem at IVA?? And yes, I have noticed the deliberate mistake in the title:( |
that is a good point you raise, i don,t intend to trim mine either but i,ve not heard about a car failing the test for having exposed chassis rails in the cockpit, maybe its cos once painted/powder coated they indeed meet the radius required :confused:
i wouldn,t worry about it as it doesn,t seem to be an issue at the test. cheers andy |
I belive most testers pass it!:)
|
No probs with mine on the SVA.
He did notice a couple of exposed nuts:eek: under the dash, that needed covering. David |
Quote:
Cheers for the reply guys, I didn't think it would be an issue, after all, the prototype went through SVA, just wasn't sure about IVA. |
Most ERW square tube does in fact have a 3mm radius on it.
Kind regards John |
Quote:
Everything else should be fine. |
Quote:
I know it is a bit rounded over, but didn't think it was that much. Sweet deal if it is:D |
All times are GMT +1. The time now is 10:45 AM. |
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.