Cp 10 - Which way up?
 

Hi folks, I see from the book that CP10 has two holes - one is 25mm from the end, the other is 31 mm from the opposite end. What I can't find in the text is which way up does it fit? It will obviously effect the height that the diff sits up so it must have been designed offset for a reason. Anyone know for sure?
Thanks in advance,
Enoch.

Mate I posted the exact same question the other day and didn’t get a definitive answer, so, I have left them off:p and when I get the diff of my Sierra I will work it out and will then have the answer for others.:D :D

Cheers Ginge

ooops , its been so long since i did those plates i can,t remember,
i,ll check the car in the morning and post info up,

cheers
andy

Cheers buddy,

That would be two more plates on the chassis

no prob,

have you found where cp24 goes ?????:eek: :D :D

i,ll get my coat
andy

Oh Andy I’m way past CP24.;)

When I first saw the question “where does CP24 go” I made it my mission to find out.

Cheers Ginge:D

The 25mm end goes at the bottom. page 45 transmission dimensions

nice one Tigmatt, :cool:

andy

:D
there,s a few new builds started since that thread, hhmmmmm it,ll come up again i think :p

andy

Tigmatt,

Well done that man that is great interpretation of the drawing.:D

It’s going on tomorrow.

Cheers Ginge