Worst day ever*
*excluding actual important events
Finally managed to get my dad to sweat it out in his workshop machining all 44 bushes down to suit the incorrect diameter end tubes I purchased ;) I was hopeful I'd be able to get the rear suspension on in an evening, after all, I had all the parts..... what could go wrong :confused: Well as it turns out, I could do what This Thread warned about and fit my rear suspension as per a 3D drawing I had in AutoCAD. The result, 8 fully welded wishbone brackets in the wrong place. I did all this around a month ago, all the spacings were correct..... you know.... just in the wrong place :D So after putting a slitting disc into my hand being dumb with frustration I'm struggling to remove these brackets. Anyone got any useful, practical advice. I the absence of useful advice, I'll accept; Read the fricking Book, Measure twice, Weld once and also DURRRRRRRR. |
Unlucky mate, I wouldn't be so judgemental as to say "read the book" but....er...you know ;)
Buy some thicker gloves too! Cheers Chris :) |
if it makes you feel a little better....
even tho i posted within the thread advising of this in the link that you gave i,ll be honest & admit i STILL put 2 brackets in the wrong place :o tho thankfully had only tacked them in. andy |
well done for keeping at it. i think i would have had to go have a little sit down for a few days to calm down.
|
Quote:
|
What a Bummer. :( :(
PM sent to you :) |
All times are GMT +1. The time now is 08:37 AM. |
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.