Roll bar
Any local around birmingham who would be able to bend my roll bar a bit more
[/url] After cutting it down I can clearly see it hasn't been bent enough Regards Steve |
Well I've just double checked the bends and they are both just under 80 degrees
79.8 and 79.7 so I'm happy with that So if I line up one side in the correct position it looks like the 2nd bend has been bent at the wrong position on the tube |
That's annoying!I guess you can split the difference and mount it slightly outboard on both sides - can't see it making loads of difference?
|
Just cut the legs down a few mill and that will start to bring everything back into line.
|
It's already cut down to book spec so don't want to go any lower
Quote:
|
It's the same on both sides
The guy I spoke to today said why not just weld it as it is? Personally I don't see a problem with doing that it's just annoying that it's not centre to the four fixings Anyone see a problem if I had it welded as it is then? Quote:
|
Rachet straps?
|
Don't think I would want to weld stress into it, also would make it a nightmare to bolt it up, but would be better wider as it gives you more protection, just think about when you fit your side panels as the may need cutting around the bar
|
Quote:
|
|
All times are GMT +1. The time now is 07:12 AM. |
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.