Haynes Forums

Haynes Forums (http://www.haynes.co.uk/forums/index.php)
-   Chassis (http://www.haynes.co.uk/forums/forumdisplay.php?f=4)
-   -   A bit of progress (http://www.haynes.co.uk/forums/showthread.php?t=6684)

tkpm 27th June 2011 09:16 PM

A bit of progress
 
2 Attachment(s)
Well i've made a bit of progress at last,

Chassis has been painted, did that take for ever,
some of the body's been fitted and hopefully the engine will be in by the weekend.

Attachment 1230
Attachment 1231

twinturbo 27th June 2011 09:30 PM

Have you got your floors in yet? I have made a start on my bodywork and the sides wont go on with my floor in place, I have had to trim the lower lip of part of the sides.

TT

tkpm 27th June 2011 09:59 PM

Yes my floor is fitted, i had the same problem with the sides TT.

I used a flap disc and hoover to smooth the back of the fibreglass, i also rounded the edge of the ally floor.

Terry

MarkB 27th June 2011 10:11 PM

Why the trouble fitting the side panels?

tkpm 27th June 2011 10:33 PM

I had slight problem with thickness of the fibreglass in a couple of places.

Terry

wylliezx9r 27th June 2011 11:20 PM

I'm having the same problems with mine, I've had to cut holy f*ck out of them and they still ain't fitting properly. Trouble is u do all the hard work building the car then a couple of ill fitting panels make :( it look shit.

flyerncle 28th June 2011 07:55 AM

Probably got a lot to do with moving away from book spec steel sheet floor,plus a couple of mill here and there,it was suggested to leave panels in a warm room for a while and it makes them more pliable.

I trial fitted mine in the garage at low temp and then warmed them in the paint booth,much easier.

MarkB 28th June 2011 08:30 AM

Something has changed then as the sides were made originally with an allowance for 16swg ali floor. Using steel on the floor causes more hassle than it's worth, if not done right it can and will distort the chassis. Ali floor should be riveted using countersunk rivets along the edge where the side panel over laps.

davedew 28th June 2011 10:53 AM

My side panels were a little tight in places, but they went over the ali floor and rivet heads no problem.

A quick thump with the plam of the hand got them on ok. They have got easier the more they have been on and off though.

MarkB 28th June 2011 11:07 AM

Sounds like a variation in material thickness then. Just be careful when sanding the corners and make sure you wear a mask as grp dust isn't too clever to breathe in.


All times are GMT +1. The time now is 03:45 AM.

Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.