Haynes Forums

Haynes Forums (http://www.haynes.co.uk/forums/index.php)
-   Running gear (http://www.haynes.co.uk/forums/forumdisplay.php?f=5)
-   -   Mx5 lower ball joint (http://www.haynes.co.uk/forums/showthread.php?t=14127)

chris_smith 29th September 2017 08:28 AM

Mx5 lower ball joint
 
Anyone had Iva using Mx5 lower ball joint needed to add a lock nut to the short bolt that goes into a thread?

TalonMotorFabrication 29th September 2017 09:45 AM

Interesting question...in theory the bolt only being held by the threaded part of the ball joint means it's not locked, how ever if you add a nyloc or even drill that out to 12mm and replace with standard M12 bolt and nyloc it is considered locked. You could of course try and find a castle nut and split pin it if you can drill through.

This the reason I don't weld the nuts on the under side of CP3/4 as using nylocs is one less simple fail to worry about...

Cropper 13th October 2017 07:03 PM

I didnít but I did add loctite


All times are GMT +1. The time now is 02:59 PM.

Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.