Pedal box/Brake cylinder
Hi all.
I am building the pedal box but the drawing on page54 dont show the height of the hole for the master brake cylinder. It looks like it is about 40mm. But If i draw a strait line from the pushrod hole in the pedal it will go down like 15mm. Is there anyone out there having foto/suggestiens of this. And i also whant to build it with the original angle on the master cylinder like Bonzo did, but i dont think that will make any differens on the height. Peter. |
Hi,
Are you using a Sierra or another car master-cylinder ? If you are using a Sierra M/C, 30mm above the lower edge of the plate leaves enough room for a 8mm bolt/nut on the lower fitting hole. Hope this will help. |
Quote:
Thank you. Peter. |
All times are GMT +1. The time now is 05:05 PM. |
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.