ECU light
I bought my donor parts already removed not a donor car, and it seems that I don't have a warning light for engine fault warning so I have 2 questions
1) does anyone know if I could add a wire to the ECU to fit one, the circuit diagrams I have show the wire as being black/yellow there isn't a wire of that colour in my ecu connectors I do have quite a few empty spaces though. 2) If it is possible does anyone know which connector and position to connect it to. Regards Mick. |
Quote:
If so all you need is a jumper wire and an led in the diagnostic port. There are lots of posts on YouTube showing you how David |
Hi David thanks for your reply but isn't that just for reading fault codes, I was thinking more of a light which comes on when ignition is turned on and then goes out unless there is a fault.
Regards Mick. |
Quote:
David |
I think the indicator LED does light up when there are codes to read If you dont jumper it into diagnostic mode too and just have the LED in there.
As a check you can unplug a sensor or two, coolant temp at the back of the engine or O2 sensor while running and see if it lights up. Cheers Stot |
No I think it is a 93 or earlier I just bought the parts and I bought a dash off EBay but I didn't realise that it was from a Eunos in KM so I bought another one Uk spec the difference is the Jap one has engine fault light in place of rear fog light but my loom is Uk spec so I just thought maybe add a light if possible
Regards Mick. |
Quote:
Cheers Stot |
All times are GMT +1. The time now is 09:16 AM. |
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.