Attachning GRP rear tube
Hi, me again :)
Another question about fitting the bodywork : the rear tube. I have a GRP rear tube, and a book chassis, which means that I have the 2 round section tube RP1 and RP2. For now, I have attached the lower edge of the rear tube under RP1. Do I have to attach it to RP2 (the top tube) as well, or will the lower attach point on RP1 + the 3 or 4 attach points I will fit on D11 rail in the same time as the rear wheel arch will be enough to hold the rear tube? I don't like the idea of having visible bolt heads on top of the rear tube, but if there is no other way... How did you guys who fitted a GRP rear tube attached it? Thanks a lot. |
I don't have any of the round tubing at the rear of my car, the rear tub is bolted around the wheel arches and underside bottom and is secured nicely.
Cheers Stot |
The were plans floating about for the alterations for the rear end. As far as I can remember the rear tubes are replaced with a couple of diagonals and a horizontal bar at the bottom....but don't quote me on it!
Russ |
http://www.haynes.co.uk/forums/showt...Grp+conversion
Just found it. There's a link that doesn't work because it is ssc website but further down there is a PDF document showing the dimensions etc Hope that helps Russ |
Quote:
Cheers Stot |
Thank you for the replies. It is a very good news for me :)
Well, it looks like I have to put back the rear suspension together, because I will spend my week-end fitting the rear wings to finish the job! Thanks a lot for the help. |
All times are GMT +1. The time now is 05:27 AM. |
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.