Does anyone have a drawing with accurate dimensions of the offset mushroom insert please?
Or just the dimensions?
Or just the offset value, as I will be able do figure out the other dimensions.
Found this drawing on my computer. The offset can be calculated from there. Cannot take any responsibility of the design tough.
Good to hear from you!
Thank you very much for the CAD drawing, that is exactly what I needed :) .
|All times are GMT +1. The time now is 10:09 PM.|
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.