Steering column bearing
Hi I recently posted about the original plastic bush, the column went through and advice was to use a bearing and thicker plate. I recently removed the book design plate etc purchased bearing etc. wondered I any one could advise if I weld thicker plate all round front outside of foot well will I be ok to just run short welds round the inside of the foot well or should I weld all round inside too?
Any help greatly appreciated. DaveyB |
I only welded the outside of the plate and did about 2 inches at a time
|
Thanks for your help
Greatly appreciated . DaveyB |
All times are GMT +1. The time now is 05:57 PM. |
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.