Angles
May seem a daft question, but what is best used to measure the angles on the box section so i am gutting at the right degree?
Cheers. Locky. |
Good luck gutting 25x25 box! I struggle with rabbits :)
|
This will do every angle you need to cut, it's what we use every day to make the compound cuts and to set the lathe for the fish mouths on the wishbone tubes.
http://cgi.ebay.co.uk/RAIZO-STAINLES... 7920252347287 |
:o :o just got one!
|
I prefer the one available from Machine Mart as it allows the steel rule guide to sit ontop of the steel box section (as it is stepped) and so ensures the guide is set at the angle using the steel to be cut as the horizontal plain.
A little more expensive but very robust & accurate. cheers andy |
One of these any good? Nice and robust and cheap..
http://www.toolstation.com/shop/Hand...0/sd150/p84416 |
I have got one of these cant fault it perfect angle every time to 0.00 deg
http://www.axminster.co.uk/axminster...er-prod783404/ |
Thanks all, i may go for the one talonmotorsport mentioned. cheap and looks decent quality. i wont be using it for much else.
Cheers. |
All times are GMT +1. The time now is 03:47 PM. |
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.