Exhausted
 

Hi guys.
I'm at the stage where I need an exhaust, I'm still contemplating a few options but don't know which route to go.
I'm only looking to keep the pinto engine about a year after iva so I don't see the point in spending the money on a stainless exhaust (and I can't tig)

My main question is do I use the stock manifold which goes 4-2 then I would need a 2-1 and use some bends to get it out the side panel
Or do I make a 4-1 manifold from the block to the exhaust?
Where is the best place for cheap decent quality mandrel bends.
Also any ideas what I would need, would 4x 180 and 4x 90 be enough (as mentioned on here before).
Lastly I'm assuming the final size depends on the exhaust (which I don't have yet) and the starting size 1.5inch to match the ports?

Hope that's not too much to answer.
Steve

Pinto Manifold kit, ebay Item number:260502699970

What do people look for when buying an exhaust, I've looked on eBay for a motorbike one, how would I know it's suitable for a pinto. I've seen someone say look for ones off a 1000cc bike but would others ie600cc be ok?

Also anywhere else to buy steel exhaust bends apart from jetex?

These guys sell mild steel bends....

http://www.thebendshop.co.uk/mandrelbends.html

Price inc vat.