Haynes Forums

Haynes Forums (http://www.haynes.co.uk/forums/index.php)
-   Announcements (http://www.haynes.co.uk/forums/forumdisplay.php?f=2)
-   -   Front upper wishbone jig (http://www.haynes.co.uk/forums/showthread.php?t=4070)

martin62 11th April 2010 11:02 PM

Front upper wishbone jig
 
Hi can someone help I was makine my front upper wishbone jig today and was trying to find a measurment for the 2 front 25x6 angled brackets.what I am looking for is the lenght of the front edge which is on 5.12 on page 63. Otherwise had a good day got all my front suspension brackets lined up and tacked up 7.30am start and had a very nice visit from transverse which was great having someone likeminded to chat too.

Bonzo 12th April 2010 09:47 AM

That measurement can be nicked from the drawing on page 61. :)

The length is given as 236mm to the centre of the wishbone bush tube

So 236mm + half the width of the bush tube. On the book spec tube, this is approximately 17mm .... Unless you have a tape measure that has fractions of a mm graduations on it :D :D

I make the overall length of the upper front wishbone 253mm.

martin62 13th April 2010 01:00 AM

Quote:

Originally Posted by Bonzo (Post 35964)
That measurement can be nicked from the drawing on page 61. :)

The length is given as 236mm to the centre of the wishbone bush tube

So 236mm + half the width of the bush tube. On the book spec tube, this is approximately 17mm .... Unless you have a tape measure that has fractions of a mm graduations on it :D :D

I make the overall length of the upper front wishbone 253mm.

Hi Ronnie sorry if I was not clear in my question but I ment the height of the 2 angled pieces that are set at 98 degrees thanks Aidan


All times are GMT +1. The time now is 11:05 AM.

Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.