Where can i buy a rollbar for my haynes chassis?
 

As the title says, who supplys roll bars, for the Haynes roadster?

Either built or flat-pack.

Complete with harness mounts.

It's just that my tube bender is very heavy duty, and will just crush the tube required for the roll bar.
To use my bender, I'd have to make it out of 4+mm wall tube!!:eek:

How much can i expect to pay?

Cheers Frank.

It's probably not the bender thats causing you the kinks in the tube but the die being the wrong shape. Most Clarke type benders are supplied with gas type pipe formers that flare too much, you need tube dies that look like the Hilmore formers. What size tube are you looking to use and much of a rush are you in?

try here
these ones are on ebay, 95 quid and 25 postage. Don't know if you think that's cheap or not, but they look the part and look good quality.

I looked at them a while back as I need a little re-design on my roll bar cross member and I am sure they where £125, nice to see they are a little cheaper.

Cheers Ginge