Hi, just to follow up on this a little (and hopefully provoke some replies).
I have double checked all measurements again against the various available sources and everything seems to be correct (or at least within a small tolerance). However, with the adjusters screwed almost fully in I have around 5 degrees negative camber on one side and 6 degrees on the other side. Surely this cannot be correct?
I am at the stage of removing the top wishbone brackets and spacing them off the chassis by around 12-15mm, that will bring the camber back to neutral and allow me a little range on my adjusters.
Unless I have gone badly wrong somewhere then this problem must have come up before?
Any help much appreciated, thanks.
|