Quote:
Originally Posted by jps
Once again this forum proves a great resource - i'm just working out where i'll fit the threaded bosses in my rollbar cross bar, pictures/info like this is really helpful.
|
Hi,
That is how I've done it.
2014-08-23_15-51-08 by
Voucht sans_nom, sur Flickr
2014-08-23_15-51-28 by
Voucht sans_nom, sur Flickr
2014-08-23_15-52-17 by
Voucht sans_nom, sur Flickr
There was a general consensus that putting the threaded bosses through the cross bar was a very good solution, and there is no need to use the 3mm steel bracket to fit them on the cross bas as explained in the book. I think a lot of builders did the same as me.
After, concerning my car, I kept the exact transversal position of the threaded bosses as explained page 53 of the book (254mm=300mm=254mm). They don't fall directly behind the harness holes of my seat, as I did my roll bar before buying the seats, and I guess every seat model has its own spacing of harness holes. But it is latterly acceptable, as, IIRC, there is a lateral angle tolerance in the regulation (needs to be checked on your IVA manual)
Then I bought Sabel harnesses. Harnesses need to be the short strap style or single seater type, as the saloon car type have way too long shoulder straps.
Hope that will help