I thought this as well, so I purchase a new set from RD for 100 squid. I was undertaking a bit of a clean up in the workshop today so decided to strip of the brake discs and push in driveshafts from them. Yes, they are different because they have a spline on the hub bearing. However all you need is a circular cap to stop the dirt getting in. Apart from that its the same casting.
I am happy to ream out the uprights to fit the bottom ball joint and rs2000 track rod end.
I could also make some basic aluminium centre strut plugs as per my build for a small cost to cover material etc if it helps anyone who would like them.
Last edited by Spikehaus : 22nd August 2009 at 07:50 PM.
|