Don't panic - I'm just not sure how the tester would look upon eye bolts poking out, but then again, the radius is certainly legit.
It just seems it is easier to get covers for the normal type, that bolt on.
As for welding the rings into the roll bar, I still intend to use the 7/16 threaded bar from the book, then screw the eye bolt into that. Apparently it's a fail if they can't see the ends of the bolt ie. it must project through the entire bracket
I must also say that I have not actually looked at a harness properly yet. I didn't realise that they only clipped in at the top, although it would make sense (I assume the clips are so someone can be extracted) because screwing eye bolts in between seats etc. would be a PITA
Sean
|