Quote:
Originally Posted by Coozer
Standard 1.8 zetec flywheel.
Mondeo 1.8 clutch plate and cover
Ct133 release bearing
Sierra DOHC or CVH starter with some of the ali ribs trimmed off the sump where it fits.
Done to death now, have a look through my blog, that may give you soem idea's.
LG,
Steve
|
Hi Steve,
Have looked at your blog and galleries but theres not much on how you made the clutch system work.
I've tried your combination listed above but couldn't get it to work and ended up machining the flywheel to take Pinto clutch.
How did you get round the release arm hitting the end of the opening in the bellhousing ? Did you cut and shut the release arm and just let the bearing run partly off the first motion shaft cover?
How much clutch slip do you get with 81/2 inch clutch on the ST 170?
BV.