Quote:
Originally Posted by gaz05
Well I wasn't happy with my front frame. I split it to reset it but ended up binning it. So I've made two new FF2/FF3. One of the reasons I wasn't happy was the angle that the brackets sat at. So I think tomorrow I might set them so the sides of FF2/FF3 sit square on to the chassis so the brackets will sit direct onto them without having to pack them out. It means the top and bottom will sit slightly skewed to the ends of FF1/FF4. Anyone see any problems arising out of doing it this way?
|
As long as the "skew" isn,t too much it should be ok, just be aware that the nose cone is made to fit the front frame like a glove, suggest maybe trial fit a nose during the process you are suggesting Gaz.
cheers
andy