Thread
:
Rear upright orientation
View Single Post
#
4
2nd January 2011, 10:08 PM
davidimurray
Senior Member
Join Date: Jan 2009
Location: Near Cardiff
Posts: 742
I welded mine in square so that the cylinder was at the top and horizontal. This meant that the bulge sits between the side plates of the upright. I then had to file a little bit out to get the flange of the cable past.
__________________
Gallery 2
http://www.facebook.com/album.php?ai...4&l=a9831a9319
Gallery 3
http://www.facebook.com/album.php?ai...4&l=3f0d42c523
Gallery 4
http://www.facebook.com/album.php?ai...4&l=efb083b7df
Gallery 5
http://www.facebook.com/media/set/?set=a.10150244028550325.366987.601005324&l=583fd5 cd3a
Gallery 6
http://www.facebook.com/media/set/?set=a.10150550640070325.430417.601005324&type=1&l =fe779b358c
davidimurray
View Public Profile
Send a private message to davidimurray
Find all posts by davidimurray