Thanks Mark
This is where i get confused ( doesn,t take much I know
)
Standard number 5 states that the REAR of the wheel guard must not terminate above a horizontal plane of 150mm above the wheel center......
so with the perspex device up against my wheel/cycle wing the photo shows that my wing is below the 150mm horizontal line ( i,ve copied the sketch from the manual onto the perspex )
and as long as the front of the cycle wing is further forward than 30 degrees & the rear 50 degrees & that the rear terminates below the 150mm line then in my opinion its within the guidelines is it not ?
The part thats confusing me is that the manual doesn,t state the rear of the wing needs to be level with the centerline of the wheel but below the 150mm parameter
Or have i lost the plot ?
cheers
andy