Ah, well I'm at work at the mo so can't provide pictures but here goes:
I've made two plates to the same profile and hole pitches as the original mounts to bolt to the engine and two plates to bolt on to the land rover rubbers that are on the way. The rubbers will be mounted to 3mm plate welded to the bottom chassis rails as per book. Then I'll bridge the gap with the box section I've mentioned. At the moment I've worked out all the angles and lengths but this is based on 40mm box. The drivers side will leave the engine at a 48.07 degree angle and is 224.77 long along it's longest length.
Hopefully this makes sense and helps!
I'm open to any criticism/suggestions
Cheers
Ash
Last edited by ashbudd7 : 7th June 2012 at 09:16 AM.
Reason: Wrong dimension
|