It's been stated before in this thread and I will repeat it.
The 4x4 transfer box on the rear of the gearbox sticks out to the right as far as the bell housing edge and the drive shaft has to pass outside of the bellhousing.
It will encroach a long way into the drivers side, you will need to push the whole engine train over or angle it quite away, I would suggest mocking up the chassis with the engine and box before any serious welding is done.
I believe the work required is more than just modding a chassis.
I would start with a basic outer frame and no tunnel in the early stages.
Interesting project but not one to makeup as you go along
|