Thread
:
Appropriate aluminium?
View Single Post
#
5
29th December 2012, 11:15 AM
Talonmotorsport
Senior Member
Join Date: Oct 2007
Location: Southminster Essex
Posts: 1,323
Make the floor in one piece and just cut the bell housing part out it will add some much needed stiffness to the chassis. If using an angle grinder and slitting disk to cut the sheet wear a mask as ali dust is a known cause of erm..err..oh...alzheimer's.
__________________
Website
http://www.talonmotorfabrication.co.uk/
Direct email
phil@talonmotorfabrication.co.uk
talonmotorfabrication@gmail.com
Mobile
office hours 07514098334
Talonmotorsport
View Public Profile
Send a private message to Talonmotorsport
Visit Talonmotorsport's homepage!
Find all posts by Talonmotorsport