Hello everyone!
Have been running my fuel lines today and all has gone well so far! But i have two.. no three questions....
1) How do you guys go about connecting 8mm copper hard line to 8mm flex lines do you just use clips to hold the tube on the pipe? Was unsure if i should put some clever type of connection on there as its fuel injection rather than carbs.
2) Also anyone know any reason why i should not put my fuel filter in the top drivers side corner of my gearbox tunnel? See pic below.
3) Do guy guys think that this type of clip will be ok? also seeing that the fuel lines are P clipped nothing will be moving around.
http://www.ebay.co.uk/itm/Universal-...item1c2d66216b
Will be going down the garage tomorrow afternoon so any replies by then would be fantastic!
