Quote:
Originally Posted by Davidbolam
Johno I have just measured mine and its 285 mm (to the back of the front cross member). I don't know how the engine could go any further back.
I might wait until you have chopped your bonnet to see that is like.
If you removed the flange without cutting the top would it fit?
David
|
I dont know the measurements because I stripped back to the chassis yesterday for painting but this photo shows how far back my engine is. The clutch rubber is in line with the upright.
I have my engine a bit further to the passenger side which gives me steering rack and inlet clearance. I'm using the Equinox bonnet and it fits without cutouts.
Cheers
Stot