Ray, I bought a couple of little books when I got the lathe, and they show this technique.
It's what I was planning to investigate. I had even got an off-cut of the 2" bar I am using ready and waiting to setup to determine the correct spacer size.
Shame the bloody thing has decided to play up, I was quite getting into using it. Might have to buy a mill next as well
Sean
Quote:
Originally Posted by RAYLEE29
just seen the size of your lathe it might be a bit small for the offset thing above my chuck is a 5 inch one may still be possible but be carefull
Ray
|
Tiny - isn't it