Quote:
Originally Posted by DRCorsa
Alga, how much caster have you calculated for the original setup?
After a bit of work on CAD, i came up with this rough figure.
I assumed a vertical distance of 200.5mm between ball joints (according to this drawing) and a slight divergence between the upper and lower wishbones towards their outer ends (ball joint ends)
|
My "tape measure applied to the side of upright" measurement indicated the distance between balljoints is about 210 mm. I based my calculation on this length, and it works out at 5.5° then. But, this does not take KPI into account, so, looks like your numbers are more accurate.