I've now finished the bracket for the brake reservoir, I originally made it out of the same ali as the rest of the panels but it was a bit too flimsy and I wasn't happy with it, so it has now been made out of the same ali as I used for the floor, which is 2mm thick and hardened was a bit of an arse to bend as you can see on the bottom edges which arent flat, I think I will give it another seeing to with the hammer to see if I can tidy it up a bit. I now just need to buy some 10mm to 8mm push in reducers for the master cylinder, cut the pipes to length, and then put a couple of rivnuts in place for the two t-pieces and the brake system will be complete.