View Single Post
  #18  
Old 21st July 2010, 12:10 AM
HandyAndy's Avatar
HandyAndy HandyAndy is offline
Senior Member
 
Join Date: Jan 2009
Location: cleveland
Posts: 3,917
Default

Quote:
Originally Posted by james3004 View Post
I was going to make it like ash has done, but i'm unsure of the height of the cross brace and the hole spacings for the bosses to be welded in
Hi James,

I have just finished my roll bar / harness mounting & have also done similar to Ash,s build, have a look at the thread titled "Hi All" in the "off subject" section, there is a photo showing my roll bar/harness mounting position...........if this is similar to how you intend doing yours then I can give you the measurements I used .

cheers
andy
Reply With Quote