View Single Post
  #1  
Old 16th November 2011, 02:56 PM
andysredmini andysredmini is offline
Member
 
Join Date: May 2011
Location: Stourbridge. West Midlands
Posts: 86
Default Mx5 Build Transmission Tunnel

Iím currently working on the transmission tunnel on my mx5 based build from the Saturn guide.

I canít seem to fathom how the new cut pieces go together.
So far i have welded in
both TT1's (2 part) to the new amendments
TT2 & TT3
TT4, TT5 & TT6 (the mitred hoop)
TT9 & TT11

Iím stuck on TT6 & TT7

Am i correct in thinking that viewed from above the modified TT7's follow the line of the new TT1's but rise up to meet SB3?
And that the TT6ís will need mitred to suit and TT8 should be cut to fit between the TT7ís.

I was late last night when looking at this so I have probably missed something glaringly obvious that explains it all.I gave up in the end and decided to replace the liner in my welder instead of continuing. Wish I had never touched it. I ended up having to dismantle the gun and part of the machine and the new liner didnít even fit. 2 hours later i was no better off than when i started.

Thanks

Andy
Reply With Quote