View Single Post
Old 13th April 2011, 08:56 AM
CTWV50's Avatar
CTWV50 CTWV50 is offline
Senior Member
Join Date: Aug 2010
Posts: 1,294

I test my welds with a big hammer!

It was 90˚s beforehand. by CTWV50, on Flickr

It's not pretty but the 2mm box started to bend before the welds even thought about breaking. Need to see if I can fold into two but I'm a lot more confident thanks to this thread and some further reading. Big BOC Argoshield bottle and 40 reg helped, just need to refine my technique a bit to be more economical but happy all the same.

Tried to switch to 0.8mm wire but the wire just kept exploding on contact with the work piece so I panicked and put some more 0.6 in could be down to the feeder but not sure.

Last edited by CTWV50 : 13th April 2011 at 10:52 AM.
Reply With Quote