View Single Post
  #28  
Old 31st October 2009, 05:50 PM
londonsean69 londonsean69 is offline
Senior Member
 
Join Date: Nov 2008
Location: Surrey/South London Border
Posts: 453
Default

Looking good tatey.

The chassis plates for the rear are dead simple. Even the ones that are used as the top suspension mounts. In fact, those ones are dead easy, just a flat piece of 3mm with some careful laying out and drilling.

The hardest bit was making the rear panel round bars. I don't know any plumbers, but if you did it might make it a bit easier to get the bars bent.

I resorted to cutting loads of 1mm slits then bending to suit. A few beads of weld along the inside once bent, and they will be hidden by the rear panel anyway
__________________
Sean
Reply With Quote