Thread
:
Cutting box section for chassis
View Single Post
#
3
19th July 2009, 05:38 PM
flyerncle
Senior Member
Join Date: Mar 2008
Location: gateshead,near cobbly bit of A1 North
Posts: 3,188
This may save you a little aggro and make the bottom and top rails a little stronger. I left them in one length and cut the angle's out of only three sides so this leaves you with a continuous length and one less weld per cut.
flyerncle
View Public Profile
Send a private message to flyerncle
Find all posts by flyerncle