View Single Post
Old 9th November 2018, 10:07 AM
jps jps is offline
Senior Member
Join Date: May 2012
Location: Colchester, Essex
Posts: 429

Originally Posted by DaveyB View Post
So I managed to tighten up my drive shaft nut to the torque required. Now with no wheels or brakes fitted it is quite hard to turn the shaft by hand is that normal ?
There is also no oil in the diff.
I've seen this mentioned elsewhere and the answer was 'yes' it can be very tight. I've torqued mine up using an impact driver - but it's only rated to about 200nm I think - so I found mine only a bit stiff with the hub on the spline and not a problem at all with the wheels back on.
Reply With Quote