View Single Post
  #2  
Old 4th October 2019, 10:25 AM
Andrew08 Andrew08 is offline
Junior Member
 
Join Date: Sep 2019
Posts: 2
Default

Hi, just to follow up on this a little (and hopefully provoke some replies).

I have double checked all measurements again against the various available sources and everything seems to be correct (or at least within a small tolerance). However, with the adjusters screwed almost fully in I have around 5 degrees negative camber on one side and 6 degrees on the other side. Surely this cannot be correct?

I am at the stage of removing the top wishbone brackets and spacing them off the chassis by around 12-15mm, that will bring the camber back to neutral and allow me a little range on my adjusters.

Unless I have gone badly wrong somewhere then this problem must have come up before?

Any help much appreciated, thanks.
Reply With Quote