View Single Post
  #10  
Old 12th September 2009, 12:27 PM
uggy uggy is offline
Junior Member
 
Join Date: Aug 2009
Location: Toowoomba.Queensland. Australia
Posts: 8
Default flatting the ends

try getting a piece of 50 x25 flat mild steel 100 mm long drill a hole in the middle 25 mm in diameter then cutting it in half so you end up with two pieces 50 mm long with half a hole in the end. place one piece on a press bed put wishbone on top then the other piece on top of the wishbone with 5 mm past the bottom of hole with the rest of the former over the plate then press it. should leave a round profile on the end of the pipe with the very end flat against the plate. try some test pieces first
Reply With Quote